|
#1
|
|||
|
|||
Knop CA Reactors
I just bought a knop C ca reactor and I am having a hard time tuning it. I set the bubble counter to 24 bubbles per minute last night and an effluent rate of 6 drops per minute. I woke up this morning and the effluent was like 3 drops per minute and the bubble rate was 13 per minute or so. I also noticed that there is a gas pocket under the piece in the media container below the black plastic piece that holds the spinge and media. How do I fix this? What should I do? Thanks.
__________________
120Gal Reef Tank 2-250W MH HQI pheonix 14k - icecap ballasts with reefoptix pendants 2-54w T5 (Blue Actinics) hydor koralia #4 & #3 |
#2
|
|||
|
|||
check your pump
is it circulating the chamber water?
__________________
120 gal. Euro design glass tank with three 400 watt PFO de and actinics. Closed loop Oceanmotion Super Squirt. 40 gal refugium, 120 gal sump. Knop/Geo reactors. All sps!! |
#3
|
|||
|
|||
I think so. I'm going to remove some of the media because I think it may be to full, then I will be able to see the top of the media and I will be able to see if it is agitated by water flow. I can see a stream of water in the air pocket it appears to be falling down.
__________________
120Gal Reef Tank 2-250W MH HQI pheonix 14k - icecap ballasts with reefoptix pendants 2-54w T5 (Blue Actinics) hydor koralia #4 & #3 |
#4
|
|||
|
|||
Yeah it looks like it is circulating water. Any other ideas?
__________________
120Gal Reef Tank 2-250W MH HQI pheonix 14k - icecap ballasts with reefoptix pendants 2-54w T5 (Blue Actinics) hydor koralia #4 & #3 |
|
|