|
|
|
|
#1
11/09/2005, 06:03 PM
|
|||
|
|||
|
DIY wood workers
I am wondering if any woodworkers have built corner or bowfront stands and hoods and if so could you post pics so I can see I run a CNC router for my job so I am really lucky it make curves and arches really easy but I'm stuck on ideas for looks I've thought of alot of stuff anyways any ideas would be greatly appreciated
__________________
What I think I know and what I actually know are two totally different things. Thanks, Kelly |
|
#2
11/09/2005, 11:26 PM
|
|||
|
|||
|
here is mine I built. Simple design but the doors drag and the boards dont line up perfectly but it is close enough and looks nice. Its made of 1x4 pine. I shaped the top and bottom using the tank as a guide then simply attached the 1x4 cutting out the doors and putting on hinges. I framed it with 2x4's. it very sturdy.
__________________
Don't read the fine print, You wont like what you read. |
|
#3
11/09/2005, 11:48 PM
|
|||
|
|||
|
92g corner bf
I just started a thread on Manhattan Reefs . I bought this 92g aga corner bowfront and the canopy it came with was too small. Besides the design did not match. The stand and canopy will completed this weekend. I do have pics up already. I just stained and did a test fit. Do to rain and extreme wind I could not do anymore today.
__________________
That rock was only 25 cents honey! |
|
|
Linear Mode
