|
#1
|
|||
|
|||
Articulating Arm
I need ideas on how to build a dyi Articulating arm that has 2 or 3 pivit points one being vertical the rest being horizontal.
Im not really sure were to begin or even were to look for the parts. any ideas would be helpful. thanks
__________________
forever a noob |
#2
|
|||
|
|||
Is this for mounting lighting or something like that?
|
#3
|
|||
|
|||
exactly
__________________
forever a noob |
#4
|
|||
|
|||
How about something like this?
I found it on this page: http://www.silentpaintremover.com/attachments.htm |
#5
|
|||
|
|||
thats it, i was hoping a dyi could be made at a much cheaper cost, i believe that one is 155.00 on there site
__________________
forever a noob |
#6
|
|||
|
|||
That model would be a good place to start some designs. No I don't know of a specific DIY for that but all the importance of the mechanism is in the locking hinges joints. I would search the net for similar joints or hardware that will do the same thing.
Tubing, pipe and some way to lock the joints. |
#7
|
|||
|
|||
How good of a DIY'er are you, how much weight does it have to hold, and how far does it need to pivot and swing?
I think I've got a good idea or two for you, but I have to leave work and need some time to sketch them up. I'll try to get back to you tomorrow, if not it will be Friday. BTW, I don't have a salt water tank (yet), but this forum is one of the best DIY places around. I've been doing a lot of looking at projects releating to my fresh water tank and my amphibian tank. Good stuff! |
|
|