|
|
|
|
#1
04/29/2007, 10:12 AM
|
|||
|
|||
Bioball/seaclone/maxijet modification
Not sure if this is the right place to post this or not .... Anyhow I have been looking for some kind of detailed instructions on the Bioball modification for the MaxiJet1200 for the Seaclone skimmers.... I have an old seaclone laying around and wouldn't mind Modding it to work in a nano ...If anyone could point me in the right direction , the help would be greatly appreciated
__________________
Eric + Candace |
|
#2
04/30/2007, 08:20 AM
|
|||
|
|||
|
I am not sure if the thread below is what you are looking for:
http://archive.reefcentral.com/forum...5&pagenumber=1 Here is some more info: http://archive.reefcentral.com/forum...t=seaclone+mod
__________________
Doug "I hear and I forget. I see and I remember. I do and I understand."-- Confucius |
|
#3
04/30/2007, 09:11 AM
|
|||
|
|||
|
Scroll down on this link there are some good pictures to help explain what you are looking for; I did it to a seaclone and it helped the only drawback for me was it caused restart issues. The plus side is it only takes a few minutes with a dremel tool.
http://archive.reefcentral.com/forum...&pagenumber=40 |
|
|
Linear Mode
