|
#1
|
|||
|
|||
What should your ozone be set at?
I have a 120 with 7/8's being SPS and some chalice pieces.
What should my ORP reading be? Some people have told me 400. |
#2
|
|||
|
|||
ORP ranges:
Very Bad : below 140 millivolt Bad : 141 to 180 millivolt Poor : 181 to 200 millivolt Too Low : 201 to 220 millivolt New salt water : 221 to 240 millivolt Low : 241 to 270 millivolt Medium : 271 to 310 millivolt Good : 311 to 340 millivolt Better : 341 to 360 millivolt Best : 361 to 390 millivolt High : 391 to 450 millivolt Too high : 450-525 millivolt Dangerous : 526-575 millivolt Very dangerous : over 575 millivolt |
#3
|
|||
|
|||
Very nice, thank you. Where did you get that list????
I set mine up last night. It is the enaley 3000UB and the Milwaukee controller. I set it up in my sump and had to return it through a PVC pipe setup packed with carbon. When I first turned it on the ORP was reading around 190ish. I came down this morning and checked before work and it was reading 300 and the controller was not pumping. I turned it up a bit, to get it to 380ish. How do you determine how many mg/hr you are dosing? I have mine turned down on the unit itself, and it's just a knob you turn, it doesn't have numbers. Just lowest and highest. My unit claims that you can dose at 500mg/hr with the air dryer. So I have the air dryer on and have it turned about a 1/3 the way open. How do you know how much to dose per hour? Thanks again and thanks in advance. |
#4
|
|||
|
|||
TTT
|
#5
|
|||
|
|||
.3 to .5 x aquarium volume!!!
|
#6
|
|||
|
|||
.3 - .5 what?
I'm lost on what you mean. |
|
|