|
#1
|
|||
|
|||
Glue or nail the top of the stand?
Which is the most common way of connecting the top of the stand with the rest of it?
|
#2
|
|||
|
|||
use drywall screws countersunk and glue and the use a wood filler to cover over the screwholes and sand.
That would probably be the best ways
__________________
If id known finding Nemo was this costly I'd probably.........still set up my tank lol |
#3
|
|||
|
|||
Glue and screw
__________________
Too young for Medicare Too old for women to care |
#4
|
|||
|
|||
What kind of glue,the thin or the thick one?
|
#5
|
|||
|
|||
if you have a air compresor you can buy a cheap brad nailer thats what i did to make my stand
|
#6
|
|||
|
|||
I used glue and finishing screws on mine. Just go by your local hardware store and pick up some water proof wood glue like titebond III.
__________________
Jimmy C. Elos 70 (30"x22.5"x20) Semi-Cube (36"36"x24" old setup) DIY Stand Build Thread http://reefcentral.com/forums/showthread.php?s=&threadid=1207997 |
#7
|
|||
|
|||
Liquidnails would work well also, and would probably hold better for the application. Most people don't know it but the glue almost always holds the wood, its the wood that breaks so its all about the penetration into the wood.
|
|
|