Tunze Master DOC kicks butt - Page 2

jimdogg187 · #26 06/29/2007, 02:35 PM

Looks great!!! And I like how they're using pinwheels instead of the mesh.

I would like to see an external model next

If Tunze can get one out before ATI (shouldn't be too hard the others things are going

) I'd like to give one a test drive

Yinger · #27 06/29/2007, 02:46 PM

Anyone ever get around to measuring the body diameter on one?

Dwarf Seahorses · #28 06/29/2007, 02:59 PM

It's nice to see that Tunze is coming out with better skimmers, the old ones were OK but these seem to be high-end skimmers.

Waxxiemann · #29 06/29/2007, 03:51 PM

Sweet, looks great.

Are they planning an external model for sure?

jimdogg187 · #30 06/29/2007, 03:56 PM

Quote:

Originally posted by Waxxiemann
Sweet, looks great.

Are they planning an external model for sure?

I asked Roger in the Tunze forum. His answer was that they do some ideas on what to do for an extrenal, they were pretty far anything concrete.

So I'm sure its in the future, but probably not for a while

ddboy · #31 06/29/2007, 11:53 PM

I would like to know what is the cylinder size?

ddboy · #32 07/04/2007, 04:45 PM

anyone know the dimension of the 9440? the cylinder size?

Andrew · #33 07/04/2007, 06:42 PM

Ask over in the Tunze forum. It should say on Tunze's website but most likly you'll have to convert it to inches from mm or w/e they list it as.

gabe3d · #34 07/05/2007, 02:15 AM

Ooh very nice skimmer, I'm thinking about getting the same one as well. Thanks for posting the pics and info. Not to be obnoxious or anything but i think it is quite normal for a good skimmer to pull out a lot of gunk when curing LR.

Andrew · #35 07/21/2007, 12:36 AM

Any updates? I'm looking into getting a 9420 for my 75 gallon tank system I'm working on.