|
#1
|
|||
|
|||
Router Guides
I am looking for a router guide for cutting circles in my acrylic. I just cant find one that looks like it does the job good locally. Just wondering what everyone here uses and how you like it. I just used a cheap circle cutter to cut some 5 1/2 inch holes but I think a router will do a better job for me.
Thanks.
__________________
Steven Cell 401-7748 Re-evaluating my tank situation at the moment... |
#2
|
|||
|
|||
If you have a router table you dont need one. Just a scrap of plywood with a screw is fine.
Don |
#3
|
|||
|
|||
Thanks Don. I will try that on my next piece. I would still like opinions on guides.
__________________
Steven Cell 401-7748 Re-evaluating my tank situation at the moment... Last edited by Prater; 11/06/2007 at 11:39 AM. |
#4
|
|||
|
|||
If you want to buy one the Jasper is the best one out there.
Don |
#5
|
|||
|
|||
for the Jasper.
__________________
If my phaser discharges off by as little as .06 terra watts, it would cause a cascading exothermal inversion. |
#6
|
|||
|
|||
Jasper it is.
Thanks
__________________
Steven Cell 401-7748 Re-evaluating my tank situation at the moment... |
#7
|
|||
|
|||
Or use a template-guide ( or bearing of the right size) and a template combo.
If a template of the correct size can be cut I'd prefer this method. The template must be of a certian size. |
|
|