|
#1
|
|||
|
|||
Where to buy Acrylic Pieces
Where can I find acrylic pieces? I want to get a few pieces to make a light stand. I am currently using metal pieces, but it is starting to rust. Anyone have any ideas? it's for a tek light and I dont want to pay 60 bucks for their stand. thanks.
|
#2
|
|||
|
|||
Paragon Plastics = Santa Ana, CA
|
#3
|
|||
|
|||
Ditto. They have a scrap pile that is pretty cheap.
__________________
Prior Proper Planning Prevents Poor Performance |
#4
|
|||
|
|||
Home Depot sells large and small acrylic pieces as well, usually in the windows section.
__________________
Phil |
#5
|
|||
|
|||
Dont mess with that home depot crap... it is rarely acryllic. Good luck getting a decent bond out of it.
__________________
Prior Proper Planning Prevents Poor Performance |
#6
|
|||
|
|||
Any place closer to Los Angeles?
|
#7
|
|||
|
|||
ebay
|
#8
|
|||
|
|||
they also have a place in el monte
paragon plastics (626) 443-6121 1901 Santa Anita Ave South El Monte, CA |
#9
|
|||
|
|||
thanks, i will go check it out.
|
#10
|
|||
|
|||
Plastic Depot next to Jeff's in Gardena.
|
#11
|
|||
|
|||
Another rec for Paragon Plastics, I have bought scrap acrylic there before.
|
#12
|
|||
|
|||
i have some scrap pieces you can have for free. most are 8" x 30" x 1/4" thick.
|
#13
|
|||
|
|||
Ditto on Plastic Depot, they know their stuff and give good advice.
Plastic Depot 758 West 190th (at Vermont) Gardena, CA 90248 Phone: (310) 217-7080 Hours of Operation: Monday thru Friday: 8:30 a.m. – 5:00 p.m. Saturday: 9:00 a.m.-1:00 p.m. Sunday: Closed |
#14
|
|||
|
|||
phatphiser, sent you a pm.
|
#15
|
|||
|
|||
mcmaster.com. They have will call in Sante Fe Springs.
--Rick |
#16
|
|||
|
|||
I've been to Paragon in Santa Ana and El Monte and Plastic Depot in Gardena. The El Monte store seemed to have slightly cheaper prices than Santa Ana if I recal correctly. Plastic Depot is more expensive than Paragon but the service there is much better and the staff more knowledgable than Paragon.
Plastic depot will also do basic cuts for free whereas Paragon will want to charge you for everything unless you know them or they feel sorry for you and you explain that this is a school project. Most scrap peices at Paragon is $2/lb at Plastic Depot it's $3/lb last time I was at either places a few months ago. |
#17
|
|||
|
|||
Go to plastics depot, over near jeff's exotic. Great prices, and they are really fair. I gave the wrong dimensions for a piece they cut for me for my fuge... and they replaced with a new piece (right dimensions) for free!
http://www.plasticdepots.com/
__________________
"It's better to keep your mouth shut and have people think you are a fool than to open it and remove any lingering doubt." -anonymous -TJ |
|
|