|
#1
|
|||
|
|||
stand
i built a stand to pun my 90 gallon tank in the wall and i used 3/4 plywood top and its bowwed slightly that both ends of the tank has a gap what would u do fill it or ?????
thanks |
#2
|
|||
|
|||
Could you post a picture or diagram of what exactly the problem is? How wide a gap? How long is the gap? Other info is helpful.
Without seeing the problem I would suggest removing the plywood top and adjusting whatever is causing the plywood to bow either by removing material from the high spots with a plane of sander or adding material to the low spots by building up with glued on shims. After that, replace the plywood. Dave |
#3
|
|||
|
|||
ide say bout 1/16 on the edges and the center is tight
|
#4
|
|||
|
|||
1
|
#5
|
|||
|
|||
did you sand the plywood for rough areas? if so you may have to shim the stands legs a liltte bit
__________________
If id known finding Nemo was this costly I'd probably.........still set up my tank lol |
Thread Tools | Search this Thread |
Display Modes | |
|
|