intake and output size of gen-x 6000

[mhj1580]

I have seruched the internet and could not find this information. I would realy apreceate it if anyone could tell me ( I am putting 2 on my skimmer and was manting to know the pcv pipe fitting needed)

[MayoBoy]

http://www.customaquatic.com/customaquatic/subsubcategorypage.asp?subcatindexid=wp-wp-p3

5/8" & 1" i.d. for discharge. It looks like it's strictly submersible and takes water in through the body.

[mhj1580]

the front cover should pop right off as did my 2400 and it should have a threaded intake and output. which for the 2400 is 1" intake 1/2" output, thanks for the link but those sizes are for the adapters for vinal tubing that comes with it.
(and yes I know that I can not spell)

[RandyStacyE]

http://www.aquamartonline.com/catalog/item.cfm/3398960/2979281


I believe the inlet is 1" and the output is 3/4".
http://www.aquamartonline.com/i//genxsubdisweb-.jpg

[Charlie Davidson]

they can be run external.. (I ran one 6months set up r/c)

[mhj1580]

thanks I needed that info so I could buy the fittings and have it all setup so I can run 2 of these on a skimmer I built. (30 gal poly drum as recirc with feed from overflow)