Need Help With Phosban Reactor 150

[Datone]

I purchased the Phosban Reactor 150, some half inch tubing, the MJ 400, and a u-tube return. The problem I am having is on the MJ 400, the half inch tubing fits on the outflow but not on the inflow. The connection on the u-tube return is also too big. Are there adaptors I can buy for this? How does everyone else with the phosban reactor have it hooked up? Thanks for the help.

[botp2k1]

Pretty much the way you described it, mj400 with 1/2" tubing from it to inflow of reactor and 1/2" tubing from outflow of reactor to tank.

[Datone]

The problem is the outflow seems to be too big for the half inch tubing. I warmed the end over the stove and that didn't work either. Also, does the MJ 400 in the tank or out. There is a picture of the pump being used outside of the tank. Thanks.

[botp2k1]

MJ400 ph is inside the tank, 1/2" tubing fits both connectors on my phosban reactor (same size). Not sure why yours is different.

[Datone]

It fits fine on the reactor. It doesn't fit on the in-flow on the MJ 400. The out flow and inflow are 2 different sizes.

[Datone]

I really feel stupid. I just figured it out. Long day at work. Thanks for the replies.