SunDragon
02/09/2004, 12:14 PM
Im going to be starting on the plumbing for my 125 in the near future, and would like to have you guys just look it over and point out any problems.
1. The two overflows will drain through Durso's down to the sump through 1" pipe. They will both have unions near the tank, and ball valves near the sump.
2. A third 1" drain will come in also from a refugium plumbed in a closet behind the tank
3. The sump will be returned by a Iwai 40RXLT. This will pump the water up over the back of the tank and Tee'd off to two outlets. Unions will be on both sides of the pump and a ball valve on the outlet as well.
4. before the outlets of the return a 1" to 3/4" T will break off so some of the return flow can feed the remote Refugium.
The picture attached shows the routing of the pipe I want to take. I ommited details like ball valves and unions, but there going to be installed.
Anyone see any problems?
1. The two overflows will drain through Durso's down to the sump through 1" pipe. They will both have unions near the tank, and ball valves near the sump.
2. A third 1" drain will come in also from a refugium plumbed in a closet behind the tank
3. The sump will be returned by a Iwai 40RXLT. This will pump the water up over the back of the tank and Tee'd off to two outlets. Unions will be on both sides of the pump and a ball valve on the outlet as well.
4. before the outlets of the return a 1" to 3/4" T will break off so some of the return flow can feed the remote Refugium.
The picture attached shows the routing of the pipe I want to take. I ommited details like ball valves and unions, but there going to be installed.
Anyone see any problems?