Iwaki pump wiring

[trueblood]

I need help on wiring a Iwaki MD-70RLZ. I am not sure what the other parts are (pic below).

Also is this a good pump for me to use?

[trueblood]

Please help JonF....

Thanks
Jeff

[frank171]

the pump black is hot 115 volt,white is neutral,yellow is ground
the relay should be 115 volt coil and dry set of contact normaly open,the white plastic is it a water sensor

[trueblood]

The white piece is a plug. The other thing is what is really puzzleing to me.

[Terry Lang]

You should not need the relay at all, just wire a power cord plug set from your local hardware store to the pump. If you need help take the pump to the hardware store and depending on the store they may wire it for you.


Simple job.. good luck

[frank171]

you dont need the relay and the recess female plug,make sure the motor is 115volt look at the id plate ,get a 3 wire cord (sj)type with a male plug on it #16 wire at least connect black to black,white to white ,green to yellow home depot should have everything

[trueblood]

THANKS ALL
I will try that. What is the relay for?

Thanks again
Jeff

[frank171]

- An electromechanical device that completes or interrupts a circuit by physically moving electrical contacts into contact with each other.