rob020880
01/08/2008, 02:12 PM
Hello everyone,
I have a Geo 612 calcium reactor. I have it all hooked up but am not yet pumping any Co2 through it. I have just setup a new tank about three months ago now and just introduced the first fish two weeks ago.
My question is should I setup and run the reactor now, or should I wait till I start putting in corals?
Does anyone have any experience with setting up this reactor using an aquacontroller jr. to control it? Where should I start? I have no idea on the following:
1. What should the drip rate be?
2. How many bpm?
3. What should the ph values be for the AC Jr?
I don't want a spike in alkalinity which is why I want to be as careful as possible. Any and all advice would be very helpful.
Thanks,
Robert
I have a Geo 612 calcium reactor. I have it all hooked up but am not yet pumping any Co2 through it. I have just setup a new tank about three months ago now and just introduced the first fish two weeks ago.
My question is should I setup and run the reactor now, or should I wait till I start putting in corals?
Does anyone have any experience with setting up this reactor using an aquacontroller jr. to control it? Where should I start? I have no idea on the following:
1. What should the drip rate be?
2. How many bpm?
3. What should the ph values be for the AC Jr?
I don't want a spike in alkalinity which is why I want to be as careful as possible. Any and all advice would be very helpful.
Thanks,
Robert