|
#1
|
|||
|
|||
Quite Overflow Box
Is there such a thing???
Any suggestions, at the moment quite a bit of girgling. Its move about 400 gph about 4 feet down. U tube goes into divided rear section then flows over and down the drain. |
#2
|
|||
|
|||
If there is a stand pipe in the drain hole, put a foam insert over it. You can get them at your local fish store.
|
#3
|
|||
|
|||
Mine isin't have a drain pipe and it sounded like a toilet flushing all thie time, I added a piece of 1" ID PVC pipe to where it was keep the water from falling into the overflow. This helped alot, then I added the foam. that helped more. Put a box that I keep my FW filters in on top of that and now all I hear is my skimmer and return pump...
__________________
If all else fails read the instructions, if that dosen't work get a bigger hammer |
#4
|
|||
|
|||
__________________
Lance H. |
#5
|
|||
|
|||
__________________
Jonathan Bertoni |
#6
|
|||
|
|||
Great link bertoni.
__________________
Lance H. |
#7
|
|||
|
|||
Quote:
__________________
"evrr bean to sea Billy--evrr smelled a fish?" "Aye capn..experience is the best teacher" |
#8
|
|||
|
|||
Both seem very useful.
Has anyone tried them? Which and how did it work? |
#9
|
|||
|
|||
I had the very same problem when I first set up my reef. I built a Stockman standpipe for each of the two overflows, like you have...with the U-tube...and it completely silenced them. If there was any complication at all, it was with the size of the hole on the top of the standpipe...I had to try various sizes. In my case, only a hole of 2/32nds of an inch completely silenced the overflows. Any bigger or smaller and there was still some...not a lot...but some noise.
__________________
Most people get results...I seem to have consequences |
#10
|
|||
|
|||
If the foam insert is cleaned once a week there should be no problem with it collecting to much detritus. Foam inserts will collect detritus after a while and it can break down into nitrates. Like I said if kept clean it won't be a problem. Foam inserts can't collect dissolved organic matter because it is dissolved. Dissolved organics can only be removed by protein skimming and adsorption media. Foam insert performs only mechanical filtration not chemical.
|
#11
|
|||
|
|||
Quote:
__________________
"evrr bean to sea Billy--evrr smelled a fish?" "Aye capn..experience is the best teacher" |
#12
|
|||
|
|||
Quote:
__________________
Tom |
#13
|
|||
|
|||
I use dual dursos, works very well, dead silent. But it took some tweaking to get the water hitting the sump to quiet down, but it is possible. I found trial and error to be my best friend during my plumbing adventures
|
#14
|
|||
|
|||
By the way, Durso standpipes are for the overflows of reef-ready tanks...the Stockmans are very similar but are generally used for hang-on overflows because they take less room and less room is available in the hang-ons.
__________________
Most people get results...I seem to have consequences |
#15
|
|||
|
|||
It is a common misconception that protein skimming is mechanical filtration, but is actually chemical. Dissolved organic matter is attracted to the surface of the bubble because of ionic charges. This is the process of adsorption.
|
#16
|
|||
|
|||
please elaborate on double durso and surso standpipes!
|
#17
|
|||
|
|||
Quote:
__________________
Tom |
#18
|
|||
|
|||
Quote:
__________________
"evrr bean to sea Billy--evrr smelled a fish?" "Aye capn..experience is the best teacher" |
#19
|
|||
|
|||
Quote:
Alot of reefers state that the only mechanical filtration you need is a protein skimmer and the only biological filtration needed is live rock/sand bed. In this way they are lumping together filter socks, canisters, hobs, etc etc with protein skimmers, not focusing in on the differences in the processes that these use
__________________
"evrr bean to sea Billy--evrr smelled a fish?" "Aye capn..experience is the best teacher" |
#20
|
|||
|
|||
Cap'n I wouldn't be too concerned about it . I think its semantics. Is it chemical because it binds materials that are attracted to the water air interface to the bubbles because of opposing charges on the materials and the water molecules? Or would a molecular change need to occur such as in denitrification to be chemical,?Wait a minute that's biological oops. Carbon attracts molecules the same way bubbles do doesn't it. Now I'm confused. I think knowing what's going on in a certain process is alot more interesting anyway. And I think the way Percula 9 wrote was clear and well put.
__________________
Tom |
#21
|
|||
|
|||
Quote:
__________________
"evrr bean to sea Billy--evrr smelled a fish?" "Aye capn..experience is the best teacher" |
#22
|
|||
|
|||
If all you want to do is quite down the "gurgling noise," take a plastic straw, cut it long enough to have it hold tight in the over flow, and place it perpendicular to the water drain. You just need to "break" the suction around that water inlet. That should help.
|
|
|