|
#1
|
|||
|
|||
Cutting Acrylic
I need to have about 4" shaved off the opening of my tank, does anyone here know how to do or have the tools. The opening right now is about 6", not wide enough to put some of the L/R that I have
__________________
If we drive on a parkway, why do we park in a driveway? Things that make you go Hmmmmmm! |
#2
|
|||
|
|||
You're talking about the bracing on the top of the tank, right? It can be done with a router, or a dremel. If you want it to look good then a jig or some guides will need to be made up and clamped in place, this is really the most difficult part.
Here's the catch... that bracing is put there to give the tank strength and to prevent the tank from bowing, or worse blowing a seam. If this happens to be a sump and you have some baffles in it then it's a different story, otherwise I'd say tread carefully.
__________________
Jacob. Visit our club: NVReefers dot org Click my red house to visit my blog |
#3
|
|||
|
|||
friendorfoe - you can route the top (messy) or possibly crack the LR in 2 then glue/tie-down the LR back together in the tank.
Scott |
#4
|
|||
|
|||
Quote:
__________________
Jacob. Visit our club: NVReefers dot org Click my red house to visit my blog |
|
|