|
#1
|
|||
|
|||
My ranco controller keeps reading E2
My temperature controller keeps reading E2 . I went to a ranco site
and they said that it says the controller is not set right when it reads E2 and I know that thats not the case anybody else had this problem. |
#2
|
|||
|
|||
yep,had the same issue with one a while back.It would give that error-usually after a power surge/loss of power.It was annoying,because the Ranco has a built in memory for power outages,but I would have to re-set it each time.This could have been a serious issue,if away on vacation.The last time this happened,the controller just kept showing the E2 & I couldn't reset it.I ended up dumping it(as I bought it used)& am now running the spare.Did you have a recent power surge?
__________________
It's not the size of the dog in the fight;It's the size of the fight in the dog! Sir Winston Churchill. |
#3
|
|||
|
|||
There might have been one. I read on line that it also means that
the compressor needs cleaned so I unplugged it cleaned the grill and it worked after turning it back on and chilled it to 77deg so will just have to wait and see if it keeps up. |
|
|