|
|
|
|
#1
01/08/2008, 02:55 PM
|
|||
|
|||
|
Had a slight mishap with an Ro container.
Fabric softener sheets fell in one of the Brute cans. I dumped the water, rinsed the can, refilled with water and bleach, rinsed again and now it is filled with water and vinegar. Is there anything else that needs to be done before I can start refilling with Ro water?
__________________
Woman points at a Yellow Tang"Is that a salt water fish?"To which I reply "yes".She then points to a Naso Tang in the same tank and asks"Is that a salt water fish too?"There are stupid questions. |
|
#2
01/08/2008, 02:57 PM
|
|||
|
|||
|
When you say rinsing with water, is it RO water? RO water has wonderful abiliites to pull chemicals out of plastic.
__________________
DRILL IT!!! |
|
#3
01/08/2008, 02:57 PM
|
|||
|
|||
|
I doubt vinager and bleach were needed. I good diluting and flushing probably would have done the trick.
__________________
Jeff ------------------------------------------------ If you work on a lobster boat, sneaking up behind someone and pinching him is probably a joke that gets old real fast |
|
#4
01/08/2008, 03:02 PM
|
|||
|
|||
|
So it should be fine?
Quote:
__________________
Woman points at a Yellow Tang"Is that a salt water fish?"To which I reply "yes".She then points to a Naso Tang in the same tank and asks"Is that a salt water fish too?"There are stupid questions. |
|
#5
01/08/2008, 07:26 PM
|
|||
|
|||
|
I would fill it with RO leave it for a day to 2 and then dump then fill again and use the new water from the second time.
__________________
Golden Rule 7,468,102: Good things take time and bad things happen 10 mins ago. |
|
|
Linear Mode
