|
#1
|
|||
|
|||
7' DIY skimmer progress
Just for those of you like skimmers, but don't venture over to DIY very often.
Skimmer Thread Not planning on updating this thread (here in the equipment forum), just wanted to give you equipment folks the heads up... All of the updates will be made in the forum linked to above (DIY) There are also several other good skimmer threads active over there right now (the tiny might thread is excellent). In any case....questions or comments may be best placed in the other thread Bean Last edited by BeanAnimal; 08/06/2006 at 10:53 PM. |
#2
|
|||
|
|||
impressive man! someone is good with a drill press and i dont even know what other kinda tools u used
|
#3
|
|||
|
|||
Thanks...
Just a drill press, router and table saw. The TS was usesd to cut the sheet goods. The router used to cut the large holes and grooves the drill press used to cut the small clearance holes. |
Thread Tools | Search this Thread |
Display Modes | |
|
|