|
#1
|
|||
|
|||
ca reactor media
what type of media should i use on high end ca setup with sps corals. thanks
__________________
striving to learn new skills and remain teachable |
#2
|
|||
|
|||
calibration
I need advice on calibration solution as well ( what ph?) Pouch or bottle? Thanks
__________________
striving to learn new skills and remain teachable |
#3
|
|||
|
|||
I use Gen-X CRM media in my calcium reactor and I use the calibration fluids in the pouches for my pH probes.
__________________
Matt Patience is the best remedy for every trouble. Titus Maccius Plautus (254 BC - 184 BC), Rudens |
#4
|
|||
|
|||
do you need them for both ph levels 7.01 and 4.01 or?
__________________
striving to learn new skills and remain teachable |
#5
|
|||
|
|||
I use ARM media in my reactor very good stuff. You really only need the 7.01 because you are using the high side of the ph. I also use the pouch they are cheap and I get a new one each time. Of course who knows how long they sit before I buy them. : )
__________________
It is never to late to do God's good work. Paul<>< |
#6
|
|||
|
|||
I was using Shuran media, but can't find it anymore, so I just switched to the larger size ARM, similar looking to Shuran, just a little smaller. So far so good. As for cal solution, I use the pouches. As to which ones, it depends if yopu are using to measure your calcium reactor effluent (use 4 and 7) or your tank water (use 7 and 10).
__________________
"Baseball is 90% mental...The other half is physical."- Yogi Berra |
#7
|
|||
|
|||
For calibrating a ph meter always at least use two points for reference. This helps in determining if your slope of your meter is good. If you can't calibrate your meter it is a good sign to replace the probe.
|
#8
|
|||
|
|||
thank you i am ordering from aquarium plants .com 4 and 7
__________________
striving to learn new skills and remain teachable |
#9
|
|||
|
|||
I use gen X, and I agree with the others. You cannot correctly calibrate a pH meter without a slope. You were correct to order the 4 and 7 calibration fluid.
E. |
#10
|
|||
|
|||
FWIW I've calibrated my probe with both 4/7 and 7/10. Reading were virtually identical.
I use ARM in my reactor. Works well. Can be tricky at first when you are dialing in your reactor for the first time. It was my first time using a reactor, so I turned the media to mush a few times with too low a pH.
__________________
Peter Click my red house to see my tank :-) |
|
|