|
#1
|
|||
|
|||
Stupid question...which end is up?
I was replacing my sediment and carbon filters last night and decided to removed the DI cartridge to clean the housing. (This is a Kent Maxima Hi-S 35GPD) Well, I wasn't paying attention and now I'm not sure which way the cartridge goes back in to the housing. One end allows water to flow down the center of the cartridge, and the other lets water in around the edges of the cartrdige.
Which end should go up? Thanks, Tony
__________________
"Baseball is 90% mental...The other half is physical."- Yogi Berra |
#2
|
|||
|
|||
my di is setup so the water comes in on the edges and out the middle
Tim |
#3
|
|||
|
|||
So does that mean the side with the holes around the edges goes up, or the hole in the middle?
Thanks!
__________________
"Baseball is 90% mental...The other half is physical."- Yogi Berra |
#4
|
|||
|
|||
The hole in the middle with the rubber gasket should go up and the holes around the outside down.
|
#5
|
|||
|
|||
Quote:
__________________
Growing old is manditory, growing up is optional. |
|
|