|
#1
|
|||
|
|||
Hmm Is there any harm when a Powerhead burns out?
Well, I am curious and I am wondering, if someone does a over mesh and causes the pump not move. And it burned out in the tank is there any harm like electricity or something entering the tank?
|
#2
|
|||
|
|||
i had a return power head FRY! once. i heard bubbles and then no flow or lights. it was in a chiclid tank and nothing died.
|
#3
|
|||
|
|||
If the plastic melted and the copper wiring got exposed you might have an issue other wise I doubt you will have a problem.
Just in case you can run some carb on in the system.
__________________
Did I write what I wrote? What the heck am I talking about! Well..... Nevermind. |
#4
|
|||
|
|||
Thanks for the info guys, I am going to mesh a powerhead and I am a little paranoid about it going stuck and dieing.
|
Thread Tools | Search this Thread |
Display Modes | |
|
|