|
#1
|
|||
|
|||
Bubble Counter, not consistent?
My bubble counter that is attached to my solenoid (Ca reactor) is not consistent. I set the bubble to 1 bps and eventually after a few seconds, it will weakened and then eventually stop bubbling. Is it clogged? What is clogged and how do I fix it? Even if I set it to a high bubbling rate and then slows down and then stop bubbling...
|
#2
|
|||
|
|||
Most are needle valves which can be unscrewed and cleaned. I also found by raising the CO2 up to 15-20 lbs instead of Milwaukees recommended 10 pounds it kept the count consistent.
|
#3
|
|||
|
|||
Increase the pressure behind the needle valve.
|
#4
|
|||
|
|||
AZDesertRat,
You're da man! That worked like a charm. It's been consistent for the the last 15 minutes. But we shall see for a long term results. But thanks so much guys!!! |
#5
|
|||
|
|||
Thats we are all here for, sharing information.
Happy Holidays! |
|
|