|
#1
|
|||
|
|||
Need some help wiring up my Ranco controller please.
Need a little direction. I know I need to wire a feed line and an outlet line. On my cord I understand green is ground, black is hot and white is neg. Correct?? On the Ranco wiring diagram things would be much easier if it was labled W,B, or G. What does NO and C mean?? Any help is much appreciated. Thanks.
__________________
-Cato "Common sense is so rare it's often mistaken for genius" |
#2
|
|||
|
|||
NO- normally open
NC- Normally closed IIRC
__________________
I have nothing to put here because all my writers are on strike! |
#3
|
|||
|
|||
"hot" is 120 blk, "neg" is common wht, NC is normally closed, NO normally open.
Don |
#4
|
|||
|
|||
OK, but what wires go where??
__________________
-Cato "Common sense is so rare it's often mistaken for genius" Last edited by chirocato; 12/01/2007 at 08:32 PM. |
#5
|
|||
|
|||
Your incoming wire the Black goes to the center tap of the upper buss. The white goes to the 'C' tap.
The outgoing wire(which should be a female plug) the black goes to the 'NO' lower buss. There needs to be a jumper wire from the "120' upper buss to the 'C' of the lower buss. The white wire of the lower buss needs to go to the 'C' tap of the upper buss. All of the green wires need to be wire nutted together for a good ground. |
#6
|
|||
|
|||
Sweet thanks guys. In the meantime I found this.
__________________
-Cato "Common sense is so rare it's often mistaken for genius" |
|
|