make any sense?
well it dosnt work well.... so the new plan is to move the output to the top so that any excess air can escape ( while still allowing some co2 buildup ) this will allow me to SEAL the top to the bucket and i will use the opening at the top to fill the unit ( using a union and a wider pipe before reducing it to 1/4
im thinking of siliconing the top inplace. but im going to try chaning the output first..
right now im leak testing it by turning hte bucket upside down.. so far so leaks.. weird... i guess the o ring was sealing
intake works by splitting the pump intake iv seen it doen on bermuda brand ca reactors