Quote:
Originally posted by melev
What, 2 isn't good enough for you? 
What you want to know is how high the TDS is before the DI resin. Can you test that?
And how long did you let it run before you took a water sample? Did you sample it from a clean cup, or from the storage container?
|
lol idk is 2 good enough?? Everyone always brags about 0 TDS... I want to brag too!
Hmm... I'm not sure how I could test that. If I take apart the filter and turn on the water I might be able to without it spraying all over. Sounds like a job for clown!
I did it 3 times. Immediately after it was like 6ppm. Then like 10 minutes later it was 3ppm. Then I made about 20g of water and it's reading 2ppm. I used a new plastic condiment cup that I stole from McDonalds lol.