I swear the first thing I am going to do after I get my 220 set up is organize my darn garage
sooo many router bits, random blades, tools, accessories etc cluttering up the place and not alot of places to put it all. My current method of putting my router blades in one small drawer with all my other drill bits sawblades etc is not working out so well anymore
I'll probably build some new workbenches with cabinets and drawers for all my crap (entire drawer for router bits etc).
thanks for all those suggestions guys. later tonight I'll shop around and get some of the bits.
So if I have this right:
Straight cutters (with offset blades) good for primary smoothing
spiral bit with trim bearing for removing the flashing.
Does anybody use spiral bits for the primary smoothing for joint surfaces?
And would an upcut bit help to bring the waste upwards, into the shopvac attachment, or do I have it backwards?