getting starboard for 90g AGA need help
 

i was wondering if anyone at home can measure the area that the cornor overflow of a 90g AGA takes up. im not home right now and i am very close to tap plastics so i just want to get over there, have it cut, and go home and install without having to go home and measure it out first!


so if anyone can help me, please do!

It looks like these things are put in by hand, i would suggest measuring yours out. Also, if you have a jig saw you can always tweak it later. I had my 92g corner tank piece cut to close dimensions but had to take a tad off in areas because silicone and such around the bottom and overflow.

I just measured mine and it is about 6-3/4" from the corner to the outside edge of the overflow.

aww darn, it looks like im going to have to go home! darn, umm how close to the glass do you have your starboard? from where my silicone ends....its liek an inch away from the glass all around, should i have my starboard cut so that it is an inch away fromt he glass aswell?

not sure that you need an inch, probably more like 1/4 - 1/2. Mine is probably only about 1/8 at some points.

darn...didnt get to read this. haha oh well thx anyway