phos reactor please help- put it together
 

I am trying to put together a phosphate reactor by kent. My brother in law gave this to me without instruction what so ever. so please help me put it together cause I do not know how and do not want to flood my floor.

here what I want to know

2 sponges ( where to they go) inside or outside or the black plastic?.

which one is the exit tube.

and how much phosphat should i put in there. thank you

pump no one?

The exit tube is the one off to the side. The inlet is the middle one. The water flows in the top and through the pipe towards the bottom. It then flows up and out of the reactor....

From the bottom it should go: black disc, pre filter, phosphate media, pre filter, black disc, and then out.....

HTH

Brad

thanks for the help.

These might help a bit


[IMG]http://i50.photobucket.com/albums/f304/dc_909/Tank%20Build/100_6172.jpg[/IMG]
[IMG]http://i50.photobucket.com/albums/f304/dc_909/Tank%20Build/100_6174.jpg[/IMG]
[IMG]http://i50.photobucket.com/albums/f304/dc_909/Tank%20Build/100_6178.jpg[/IMG]
[IMG]http://i50.photobucket.com/albums/f304/dc_909/Tank%20Build/100_6180.jpg[/IMG]

approximately how much phosphate media should I put in there?