how do you prime your over flow box.
how do you prime your over flow box.
|
I use a U tube type overflow.Place a piece of airline tubing in the U tube. Place the U tube in place, one end in the tanks box the other end in the box outside the tank. Ensure that both ends of the U tube are under water(you will most likely have to add water to the O/S box) Now just suck the ir out of the tube and your siphon should start. Caution (salt water tastes pretty nasty )
|
no it is really nasty.
|
I use a balloon on one end, fill it with water (the U tube) then balloon the other end. put it in place and remove the ballons, siphon starts.
|
you could use the method that CRP uses with the TOM aqua lifter. Drill the top of your utube and stick in the aqua lifter just a little bit and put the other end in the drain side. That will always keep a constant syphon going and if your power ever goes out, once it comes on the awualifter will ensure your syphon is still there.
|
Don't drill your u-tube! It will hold a siphon fine in a power outage. As long as you have decent volume going thru it the bubbles will siphon out too.
|
All times are GMT -5. The time now is 07:07 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.