Got mine here
[url]http://www.dwyer-inst.com/htdocs/FLOW/qsFlowTOC.cfm[/url] Ebay has them too. Well that pump should be fine for feeding it. It just sounds to me like you are not getting enough air into the skimmer, thus there is more water in there. Did you mod the venturi on both of them recirc pumps? Its odd that the water level varies so much. Either the feed pump is having troubles and is not consistant, or you aren't getting a consistant amt of air into the skimmer. Any pics? |
Which dwyer did you get? I have pics here
[url]http://archive.reefcentral.com/forums/showthread.php?s=&threadid=1181623&perpage=25&pagenumber=24[/url] I dont have any of it running and can take some in the morning. The feed pump is fine as this setup has been running for 6 months prior to modding it. |
I have the RMA-23
[url]http://www.dwyer-inst.com/htdocs/flow/SeriesRMPrice.cfm[/url] But its in L/m. Get one thats scfh. I think you just need to fine tune it so that the air/water mix is better, but its tough not being able to see whats going on. |
I think Im going to go down to 2 layers of enkamat per pump. This still gives me a total of 4 for the skimmer. Ive seen on this post and others that the recommended is 3 layers of enkamat for the 150. So I think the extra 2 layers is causing to skimmer to over flow. Ill keep you posted.
|
[QUOTE][i]<a href=showthread.php?s=&postid=11570703#post11570703 target=_blank>Originally posted</a> by teog [/i]
[B]I think Im going to go down to 2 layers of enkamat per pump. This still gives me a total of 4 for the skimmer. Ive seen on this post and others that the recommended is 3 layers of enkamat for the 150. So I think the extra 2 layers is causing to skimmer to over flow. Ill keep you posted. [/B][/QUOTE] Are you feeding with garlic?? Garlic always messes with my skimmer and makes it overflow. |
well mine is the 200 and when I got up to 30 scfm I had to take my gate valve off and cut the stock riser tube to make the water level lower in the skimmer. The volume of air inside increased to much with the mods
|
teog i responded to your pics in the other thread. Mr Bojangles is right, you are getting too much air into the skimmer. Either raise the neck, lower the exit, or limit the air into the skimmer with valves.
|
I would say remove a layer of mesh on each pump before you try restricting the air intake...both will serve the same purpose, less air...but in removing a layer of mesh you will be moving less water (a good thing) and using less watts (another good thing :)).
|
My killawatt is acting up, i get readings of 190v instead of 120. Also it sometimes says 44w when there is nothing plugged in. Is there a reset on this thing or something??
|
All times are GMT -5. The time now is 08:10 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.