adnup
04/01/2006, 10:14 PM
Hey guys,
I was reading this article: http://www.tankblogger.com/ViewSlideShow.aspx?SSID=5
I was figuring that if I get that non-drilled 55 I could drill like that. Do you think I need a drill press? or would a hand drill be ok?
Also do you think these bits would be ok? Its what they used in the above article http://cgi.ebay.com/45mm-Diamond-coated-drill-bit-bits-hole-saw_W0QQitemZ6567178132QQcategoryZ4843QQcmdZViewItem
Thanks Paul
I was reading this article: http://www.tankblogger.com/ViewSlideShow.aspx?SSID=5
I was figuring that if I get that non-drilled 55 I could drill like that. Do you think I need a drill press? or would a hand drill be ok?
Also do you think these bits would be ok? Its what they used in the above article http://cgi.ebay.com/45mm-Diamond-coated-drill-bit-bits-hole-saw_W0QQitemZ6567178132QQcategoryZ4843QQcmdZViewItem
Thanks Paul