BC29 with chiller ?'s

[my2girls]

This is my first post in this forum. Got my BC29 hooked up with a Current 1/15 Prime chiller. The chiller instructions are not good at all. The water inlet and outlet are not marked. Does it matter? The darn thing turns on every 2 minutes (running for a minute at a clip). BTW- the inlet pump (MJ1200) is in chamber 3 and the return is in chamber 1. I've read about bad temp sensors on these things. What do you guys think? Thanks!!

[SOULEMAN]

on my 1/10th chiller by prime the inlet is on the back and the outlet is the one more towards the front of the chiller. I think it would matter if you were pumping it in backwards. it might be because u r putting the return to the 1st chamber and once the pump sucks it back in from the 3rd chamber it notices it has corrected the temp. on my bc 29 i have the return going into my actual display area and the inlet pump in the 3rd chamber.

[my2girls]

On the 1/15 both are parallel. So there is a left and right. I have the inlet on the left and the outlet on the right.

[The Saltwater Kid]

Monitoring this thread as I am looking at the same model nano chiller for my BC29.

[my2girls]

I have an email into Current USA. I can't believe nobody else has had this question. I searched all last night b4 posting this thread.

[my2girls]

I just heard for Current via email. It does not matter which is the inlet and outlet.